Router Table (Pt. 10)

Most are familiar with the saying “measure twice, cut once” well apparently twice isn’t enough for me. Tonight I routed the recess in my top for the router lift. After removing the template,  I spent a good 5 minutes cursing at myself.  Some how, I managed to rout the recess 2 inches off center. Thus I have to start over, because being off by that much is unacceptable to me. What irritates me the most,  is that my shop is covered in a thick layer of MDF dust for no good reason.

MDFDustSmall

Posted in: Power Tool Woodworking
Part of the Project

Leave a Reply

Your email address will not be published. Required fields are marked *